configure PRI norstar 0x32

[sashan]

I wanna learn how to configure a PRI line. I don't know where to start.

thanks

 

[RikRodgers]

Where are you having trouble? I assume you've got a MICS, DTI card, and PRI enabler.

After your hardware and keycode are installed, goto Maint, and disable the card. Goto Hardware, and change the card type to PRI. Make sure your settings reflect the CO's settings. (ESF, B8ZS, etc...)

Build your DID's, making sure your receive digits reflect what the CO is sending.

Build a route and destination code to dial out on the PRI.

I'm sure there's a FAQ on this.

 

[ILECCLEC]

That's a subjective question.

Configure at the CPE? the Switch/C.O.?

Read this...

http://www.jaymzworld.com/pages/linux/pages/isdn_jobaid.shtml

I can help you on the design side at the CO level and others can help you on the CPE level as I only know Norstar from the field days.

 

[rbruce2]

Be sure to check the clocking under the hardware/PRI settings. For instance, if you leave an analog card in the first slot it may try to set the PRI/DTI card as the secondary clock source.

 

[chirkware]

I just did one (my first). The FAQ section of this forum has a good guide...helped me a LOT.

 

[silver987]

faq799-1646

http://www.silverlakecom.com