Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Configure a E1 card , OPC 11C and Passport 4460

Status
Not open for further replies.

acajoee

Technical User
Oct 16, 2003
10
US
Anybody can help what i need to configure this?..

Passport 4460 and Meridian 1 OPC 11C with an interface E1.
 
Hi,
Depending on what kind of E1 card you have in your Opt11c. I did it a couple of years ago... At that time P44XX could provide Voice Networking with E1 interfaces that would have R2 DTMF signalling or voice transport for E1 PRI2. For Voice Networking, e.g., you have to have a DTI2 card and a DTMF sender/receiver (built-in CPU Sender/receiver "card 0" works fine). In Opt 11c: LD17 - add your loop for DTI2, create route (LD 16), trunks (LD14), make sure the trunks are DTMF. In passport-> follow the instructions in the passport doc's. They also available on Nortel's web site.. P.S. Make sure CRC control is checked or unchecked on both sides. Regards, Alex...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top