Config TLU25

[149149149]

How I configure TLU25(board ID 32), if it´s PASSIVE? How I configure outgoing calling at EX telephone?

<cnlip:dev=yes,lim=2;

LIM CONFIGURATION
LIM NUMBER 2
LIM CONTROL LIM CONTROL NUMBER OF SERVICE
SYSTEM SIDE SYSTEM STATE PCM-LINKS STATE LIM
A EXECUTING 2 ACTIVE
B NOT EQUIPPED
MEMORY MEMORY MEMORY SPARE
VOLUME SPARE AFTER PACKING
65535 KB 37623 KB 37623 KB
BUAR1 2520 KB BUAR2 1960 KB
CURRENT INTER LIM SIGNAL PACKET LENGTH: 90
INTER LIM SIGNAL PACKET LENGTH CAPABILITY
BPOS CAPABILITY
002-0-00 90
002-1-00 90

DEVICE BOARDS
NUMBER OF
BPOS BOARDID INDIVIDUALS SERVICE STATE
002-0-00 36 32 ACTIVE
002-0-10 102 32 ACTIVE
002-0-20 57 32 ACTIVE
002-0-30 57 32 PASSIVE
002-0-40 77

 

[00151515]

where is your location? do CNHUI...

 

[149149149]

<cnhui:bpos=2-1-73;
ORDERED

SPONTANEOUS PRINTOUT

CONFIGURATION HARDWARE UPDATE
BPOS=002-1-73
POSITION ALREADY ASSIGNED
END

 

[149149149]

<cnboi:brdid=32,numind=2,bpos=2-1-73;
CNBOI:BRDID=32,NUMIND=2,BPOS=2-1-73;
SURE? (YES/NO)
<y
NOT ACCEPTED
POSITION ALREADY OCCUPIED

SPONTANEOUS PRINTOUT

CONFIGURATION HARDWARE UPDATE EXECUTED

 

[00151515]

check if this tlu is already assigned, roedp:rou=all,tru=all;
if it is assigned remove it by roeqe
if not assigned, end the board, cnboe
remove it from the mag and re-insert it back in
chk again cnlip

 

[149149149]

<ROEQI:ROU=80,TRU=002-1,EQU=2-1-73-01;
NOT ACCEPTED

LICENSE IS NOT AVAILABLE

 

[00151515]

yo!!! Don't know about these.. help!!!guys!!!somebody...

 

[whosrdaddy]

if a board shows up passive in CNLIP it is already recognized by the MD110 , but there it is not programmed. Anyway, it is clear you don't have the neccesary licences to activate trunks on that card. check your local service partner.

http://www.damovo.com