Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Conferance warning tone

Status
Not open for further replies.
I2007

I2007

Programmer
Dec 13, 2004
506
NO
Hi.

Does anyone know how to turn of the conferance warning tone in rls 5? In opt11 prior to Rls 5 you could turn this off in ld97 on the xctp type. But iv'e never done this in rls 5.

I2007
 
Sort by date Sort by votes
You have to change the CFWT prompt in LD 56 FTC table, then init the PBX to make the changes active
 
Upvote 0 Downvote
SW2 POSITION 4 TO ON

OLD ROLMEN WORKING ON NORTELS
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MoJHK
  • Locked
  • Question
Busy tone after hangup
Replies
1
Views
103
MoJHK
MoJHK
Tjets55
  • Locked
  • Question
Expensive Route Warning Tone
Replies
1
Views
73
Firebird Scrambler
Firebird Scrambler
cable_bunny
  • Locked
  • Question
No ringback tone from 81c PABX from Incoming TELCO CO trunk
Replies
4
Views
133
cable_bunny
cable_bunny
jtony2976
  • Locked
  • Question
Opt11 Meridian 1 sending warning at boot proccess - Unable to find statrup script
Replies
12
Views
244
Firebird Scrambler
Firebird Scrambler
SherWat
  • Locked
  • Question
Page Route and Trunk - getting busy tone on disconnect
Replies
1
Views
66
KCFLHRC
KCFLHRC

Part and Inventory Search

Sponsor

Back
Top