Como es el pinout entre una tarjeta TLU76/3 y una tarjeta SANGOMA a101

[5533vita]

Necesito por favor me digan como es el pinout o arreglo de cables tanto en el conector tipo ERICSSON como en el conector RJ45 en una tarjeta SANGOME para ser instalada en un servidor ASTERISK.

Mucho agradecería la ayuda ya que a este nivel de cableado no conozco mucho.

Gracias

 

[rfpup]

IS it PRI or BRI?

 

[rfpup]

Ops, you say TLU76 so there is no BRI
TLU76/3 is E1 channel 2Mbit so pins 1&2 and 4&5 are Tx and Rx

Pins 1&2 of Ericsson to 4&5 of SANGOMA and 4&5 of Ericsson to 1&2 of SANGOMA.
Use a Crone block to connect both cables

 

[5533vita]

Have you a diagram, figure or illustration (using a typical connector block Ericsson / RJ45 in each side) where appears those information? just to see whom is 1,2,3 and 4. I apreciate it.Tthanks.

 

[rfpup]

Ericsson cable for TLU76 has only two pairs (or four wires. each of the pair is easily distinguished because it has a white wire). You need to prepare an ethernet cable only with one RJ45 connector and at the other side open (without connector).
Then use a crone block and a crone punch tool to junction these two cables with each other.
Pins 12&45 of RJ 45 connector can be seen in the connector meanwhile it is transparent, the only thing you can do is make two tests:

a. 1,2 of ethernet to one of the pairs of Ericsson cable and 4,5 of ethernet to the other pair of Ericsson cable
b. if there is no success based on above just exchange the possitions of 1,2 with 4,5 and vice versa towards Ericsson pairs.
Hope this helps