Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Command line for label and mount tape 1

Status
Not open for further replies.
Hiyahoo

Hiyahoo

MIS
Mar 4, 2003
20
US
Here is the command line for single tape device:

nsrmm -l -b"pool name" -m -y


Enjoy~
 
nsrjb -l -Y -b"pool" -S(first-slot)-(last-slot)
bye

 
with nsrjb, you use a capital L for labeling.
 
What is the point of this thread? No-one asked a question, why did someone randomly post a command?
 
Status
Not open for further replies.

Similar threads

Tom_001
  • Locked
  • Question
How can I get tape list from save set particular
Replies
0
Views
235
Tom_001
Tom_001
Martha_SysAdm
  • Locked
  • Question
Which hardware and software can i consider for Backup and Disaster recovery 1
Replies
3
Views
358
goombawaho
goombawaho
LucilleWJarrett
  • Locked
  • Question
All points are well and important
Replies
1
Views
238
iggsterman
iggsterman
anil5555
  • Locked
  • Question
Networker in HA ( High availability ) for DR
Replies
0
Views
252
anil5555
anil5555
Austilophitecus
  • Locked
  • Question
Media mount failed. User canceled a Physical Volume Library operation.
Replies
0
Views
286
Austilophitecus
Austilophitecus

Part and Inventory Search

Sponsor

Back
Top