Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Command for Modem 9006.5
- Thread starter alex617
- Start date
Easiest way (for me) is to go into EMML, then Administration, then Switch Monitor Funtion. That is where you enter the phone number it dials out to send alarms to and program in your switch ID so it identifies itself.
If you are asking how to change what port in the system is configured to work with the callout adapter I don't know how to do that.
If you are asking how to change what port in the system is configured to work with the callout adapter I don't know how to do that.
Alex you say service port and cbx monitor. Are you sure your talking about a Hicom 9006.5 PBX? Or are you referring to a ROLM 9005?
If you referring to a Hicom 9006.5, use ADD-BCSM:UNIT=A1,TYPE=DPP,LINE=9,RMX=N;
DPP Line 9 is for the CCA modem.
If your referring to the ROLM 9005, use LI PORT IMON to view it. If you want to modify it, go into config and use sio_port.
If you referring to a Hicom 9006.5, use ADD-BCSM:UNIT=A1,TYPE=DPP,LINE=9,RMX=N;
DPP Line 9 is for the CCA modem.
If your referring to the ROLM 9005, use LI PORT IMON to view it. If you want to modify it, go into config and use sio_port.
- Status
