CO Trunk

[tiaka]

Have a question I have a G3si configured a co trunk hooked to an Amphenol to a 66 block.

Is there any special punch down order for a 66 block?

I have connected the first consecutive pairs to analog lines from carrier but only one line shows active in the switch under "stat trunk"

Help

 

[AvayaTier3]

every third pair for an 8 port board

http://www.tek-tips.com/viewthread.cfm?qid=1623055&page=1

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

37 years Bell, AT&T, Lucent, Avaya
Tier 3 for 27 years and counting

http://bshtele.com

 

[tiaka]

Just so Im clear. Would this be right

X 1 Pair ok to use
X 1 Pair ok to use

o 2 Pair Skip
o 2 Pair Skip

o 3 Pair Skip
o 3 Pair Skip

X 4 Pair ok to use
X 4 Pair ok to use
etc

 

[AvayaTier3]

yes, If you click on the link above that I provided, it will show you the wiring and colored pairs for each circuit.


A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

37 years Bell, AT&T, Lucent, Avaya
Tier 3 for 27 years and counting

http://bshtele.com

 

[tiaka]

Thanks sorry didnt check your link

 

[tiaka]

Doing a 911 test this morning after carrier added a trunk Location for 911. I dialed 9911 and got the following error.

list trace station 8109
active station 8109 cid 0x1e
dial 9911
term trunk group 5 cid 0x1e
dial 9911
denial station 8109 cid 0x1e
denial event 1643: OrgGrpTyp/alrtCOS/LIT tmo D1=0x1ce D2=0x1e
idle station 8109 cid 0x1e
TRACE COMPLETE Stations 8109 cid 0x1e

Anyone have any clue how I can fix this I check the FRLS for route is = to FRL/7 for COR/7