Looking for a solution to an issue with low volume on a specific CO trunk. The volume is extremely low. This is most likely a provider issue but wanted to know if there is a way to increase this from the switch. It is an S8500 running Communication Manager 3.1.2.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CO Trunk Volume/decibel gain
- Thread starter mdefedele
- Start date
cellrebral
IS-IT--Management
I don't know of any way of fixing this through the switch, but check out for info on adjusting the loop current and circuit loss on a line or trunk.
Trunk Gain
This field specifies the amplification applied to the trunks in this group.
Valid entries Usage
high Enter high if users complain of low volume.
low Enter low if users complain of squeal or feedback.
You could try setting the trunk gain to high but it may end up increasing any noise level you have
This field specifies the amplification applied to the trunks in this group.
Valid entries Usage
high Enter high if users complain of low volume.
low Enter low if users complain of squeal or feedback.
You could try setting the trunk gain to high but it may end up increasing any noise level you have
- Status
