Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CM 6.3 and old PMS link

Status
Not open for further replies.

MiikeMoriss

Vendor
Sep 5, 2012
19
CA

Hi

Recently install 8700 cm 6.3 with 450 GW to replace an old definity. Our costumer use call accounting connected to data module to communicate with the Definity trhu an digital port (data module port)

When trying to add data module in the 6.3, I have an error in the type fiel when typing the port of the G450 01v0224,. 'port number error,(cabinet 1-64, carrier A-E)

I have the procedure for the ip solution but is it still possible to use digital data module with this version of CM? The PMS will upgrade to IP but just in two weeks..

thanks a lot.

MM
 
Digital data modules have gone away long ago. A terminal server would be needed if you cannot wait for the PMS to support IP. This will convert the IP data link provided by CM to a serial link. There is plenty of documentation out there on how to setup the IOLAN product for this purpose.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top