Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CLIP No Screening with SIP

Status
Not open for further replies.

Agent0007

IS-IT--Management
Oct 8, 2015
86
DE
Good day!

I have a question, where can I find the settings for the CLIP-No Screening in the eMG system?

Thank you!

Best regards,
RR
 
RR

We have to make sure 'CLI Flexibility' is active on our SIP providers portal. Then we use the CLI STA in pgm 113. Line 12 - STA CLI 1 Enter full number you wish to display.

Cheers

Eats


Ok, Press Trans *#..... TRANS/PGM..... the transfer key?.......sigh!
 
Hello Eats,

thank you for the response! I will contact my SIP provider about it, is it only in PGM 113? no other settings?

Thank you!!

Best regards,
RR
 
RR

PGM 151 in CO Line Attributes, COLP and CLIP Index set both to 'Use Station CLI', add the zero in for 'My area prefix code'.

Should be ok with that. All depends on the SIP provider really, we use Gamma which is IP Address authentication.

Eats

Ok, Press Trans *#..... TRANS/PGM..... the transfer key?.......sigh!
 
Hello Eats!

Got it to work with those settings you mentioned and some settings on the SIP CO Attributes, ID Individuality. thank you very much for the help!

Best regards,
RR
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top