Client's configuration is not verified

[vpn13]

I have setup my vpn. (i have 25 hosts allow)
The problem is that, i can connect(my securemote says connected) but i cannot ping or telnet. Message is : DROP Client's configuration is not verified.
FW-1/VPN NG FP3= solaris 8
securemote on winXP

other question: my license is 25 internal hosts, but if i have over 50 nodes configure on the firewall, could this be a problem?

 

[Packet7]

As far as I know, your FW-1 will need to be licensed for +VPN. Also, check your SecuRemote topology file (user.C). Is it downloading to the client properly? This is where SecuRemote learns the VPN topology and is aware of resources. I always start testing pinging the FW, then the LAN default gateway.

Hope this helps.

Rgds,

John Judge
MCSE, MCSA, MCP, CCNA, CNA, Network +, A+

 

[Proacsafe]

Hi,
The problem may be due to having the apply Rule only if desktop configuration options are verified is enabled.
Try to add the service FW1_scv_keep_alive to client encrypt rule.

-Alon