CLID wrong display after upgrade 1

[dlesap]

Hello

Last week i upgrade an CS1000S Rls 3.00 to Rls 4.5.
SigServ and MC were also upgraded succesfully.
System is correctly patched or seems to be...

I have only IP phones on that PBX. It's connected to another Opt81C through MCDN.

After registering, all IP phones upgrade their firmware from D31 to D98.

When a call is coming from PSTN (Opt81C - MCDN- Succ.) the CLID of caller is now displayed twice (CLID 0765432100 appear as 07654321000765432100)

In the MCDN DCH it's only appear single.
When the call is internal or from a Opt81 phone, display is correct.
All displays were correct in Rls 3.00

Any suggestions?

 

[Muddyheel]

Turn off CLID on remote switch

 

[dlesap]

Tell me more..
I don't understand what you wish i try to do!!

 

[johnpoole]

pbx to pbx tie, make that an int route, and that will (should) kill clid from the remote, it sees it as a ext and uses the clid table as programed in the 81.. might still be a patch, if that didn;t work i would have nortel on it.. just because the patch is not on the site does not mean that it's not a patch problem.. had one added yesterday, that is still not on the dep list.. but it was written via nortel to solve a ini problem

john poole
bellsouth business
columbia,sc

 

[dlesap]

Hello guys

That problem is solved :
CLID was wrong on i2001/i2002 only
Nortel patch for SigServ p20774_1.ss1 is necessary

 

[johnpoole]

you just solved a problem months before i had it.. it's nice when you find a great tip and take time to share

john poole
bellsouth business
columbia,sc