CLID on analog sets

[maripaq]

I would like to know if I need 1 NT5D60 per system or 1 per network group to display CLID on analog sets? I have an OP81C running on rlse 25.47.

Thanks

 

[unkalary]

One per system

 

[maripaq]

Thanks! Where can you find this info in the NTP's?? I have look averywhere but could'nt find it!

 

[roupe]

First place I'd look is ld 22 PRT PKG to make sure you have software pkgs 95 332 and 333 required in addition to the CLASS modem card. Then LD 15 to configure the CLASS CLID parameters, LD 10 to configure CLASS calling name and calling number delivery for analog sets, then LD 13 to configure the CLASS modem unit..

 

[jhonm]

You should have ISM for CLASS feature also.

 

[HHdidit]

Maybe, depending on the configuration. The NT5D60 card is like the DTRs used to collect digits from 500 sets with DTN class of service, a shared resource. If one card will handle the requests, that is all that will be required. The engineering rules are in NTP 553-3001-149.

Also note that the CLASS information is delivered in the silent interval between the first and second ring. If the called is answered quickly, the CLID information will not display. (Ran into this with an IVR that was using the feature, and set up to answer immediately.)

 

[maripaq]

Thanks! I will look this up and ket you know.

Cheers.