I am getting a new Cisco3548 in tomrrow. I am new to the Cisco switch line. I have dealt with plenty of their routers though. What I am wondering is if there is any special config I have to do to get them to work or can I plug them in straight out of the box and go.
Also I am interested in using some of its layer 3 capabilities.
What I have is three different class C address's and I want them all to use the same gateway. Is this possible. For example I have
20X.1XX.4X.1 as a gateway
I want 20x.1XX.4X.2-254 to use this as a gateway
I also want 20X.2X.3X.1-254 to use this as a gateway
and I want 20X.2X.4X.1-254 to use this as a gateway.
How would I go about starting to configure the switch so all this will work or will it work.
Thanks
Ron
Also I am interested in using some of its layer 3 capabilities.
What I have is three different class C address's and I want them all to use the same gateway. Is this possible. For example I have
20X.1XX.4X.1 as a gateway
I want 20x.1XX.4X.2-254 to use this as a gateway
I also want 20X.2X.3X.1-254 to use this as a gateway
and I want 20X.2X.4X.1-254 to use this as a gateway.
How would I go about starting to configure the switch so all this will work or will it work.
Thanks
Ron