Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
cisco supervisor engine
- Thread starter duster123
- Start date
If it is using CATOS the command is 'show module'. Will give you an output like the following:
Switch (enable) show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X4013 no ok
2 2 34 Router Switch Card WS-X4232-L3 no ok
3 3 48 10/100BaseTx Ethernet WS-X4148-RJ no ok
Switch (enable) show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X4013 no ok
2 2 34 Router Switch Card WS-X4232-L3 no ok
3 3 48 10/100BaseTx Ethernet WS-X4148-RJ no ok
- Status
