I have an Cisco serie 800 with a ISDN interface for dialup net access and one Ethernet port.
the problem is that when i connect to the console port, with a console cable, i open Hyperterminal or i just telnet to the com1, then i notice that the router is in RomMonitor mode, the prompt is this one:
Boot>
but when i try to send commands, the router doesn't respond or it gives trash characters....
what could be the problem? router rom is fucked? or i have missed something in my telnet configuration?
i apreciate any help or comments on this one, thanks
Tron
the problem is that when i connect to the console port, with a console cable, i open Hyperterminal or i just telnet to the com1, then i notice that the router is in RomMonitor mode, the prompt is this one:
Boot>
but when i try to send commands, the router doesn't respond or it gives trash characters....
what could be the problem? router rom is fucked? or i have missed something in my telnet configuration?
i apreciate any help or comments on this one, thanks
Tron