Hi. Sorry for being the newb. I've done a bit of reading and couldn't find an answer. I don't have enough experience with the hardware to determine what I need in order to set this up.
At work, I've only programmed a few routers but don't understand much about the hardware (eg, the cards that go into the back of the routers).
I'm looking to get a cisco 2600 router for home use. I looking to get CCNA certified. I find it easier to study this at home rather than use the resources at work simply because I feel moments of inspiration and ingenuity arise at spurs of the moment. I find my spurs usually come at home.
Enough background:
I wanted to set up my router such that my internal network goes through my router which is then connected to my cable/dsl modem via ethernet as well. I was planning on using the built in Eth0/0 for my internal. Where would my external network connection go? At work, I notice we use a T1 card but I don't know if that'll work at home as I can't afford the luxury of T1. What card would I need? Is this even possible?
Thank in advance!
At work, I've only programmed a few routers but don't understand much about the hardware (eg, the cards that go into the back of the routers).
I'm looking to get a cisco 2600 router for home use. I looking to get CCNA certified. I find it easier to study this at home rather than use the resources at work simply because I feel moments of inspiration and ingenuity arise at spurs of the moment. I find my spurs usually come at home.
Enough background:
I wanted to set up my router such that my internal network goes through my router which is then connected to my cable/dsl modem via ethernet as well. I was planning on using the built in Eth0/0 for my internal. Where would my external network connection go? At work, I notice we use a T1 card but I don't know if that'll work at home as I can't afford the luxury of T1. What card would I need? Is this even possible?
Thank in advance!