Hi,
I have setup a terminal session with the Cisco Pix Firewall. I logined as username:enable then gave my password. I got the following prompt "Firewall#" which I beleive is putting me in edit mode. I tried adding a statement to the pix but got back an unrecognized error message. How do I get in edit mode to enter in some configuration changes. I don't want to change everything just want to add a few lines to config.
Thanks,
jj
I have setup a terminal session with the Cisco Pix Firewall. I logined as username:enable then gave my password. I got the following prompt "Firewall#" which I beleive is putting me in edit mode. I tried adding a statement to the pix but got back an unrecognized error message. How do I get in edit mode to enter in some configuration changes. I don't want to change everything just want to add a few lines to config.
Thanks,
jj