CISCO PIX 501 DEFAULT ID AND PASSWORD 2

[ciaociao77]

Hi,
I have a cisco pix 501 firewall and I'm trying to restore the default parameters, so I launched the command "configure factory-default". Now through putty software I can reach the new IP address but I can not access. What is the default user? and password? I tried USER: pix PASSWORD: cisco but it does not work.
Thanks
Alessandro

 

[burtsbees]

I believe you just hit enter...there is no password. Also, the command "wr erase" from priv exec will bring it to factory defaults...if that doesn't work, you can always do a password recovery---I know on the PIX520 it involves a floppy, but I don't think the 501 has a floppy, does it?

Burt

 

[Supergrrover]

For enable access, there is no password. If you need to do a full recover here is the process

http://www.cisco.com/en/US/products...ducts_password_recovery09186a008009478b.shtml

Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[ciaociao77]

To resolve this problem definitively, I have chosen for a full recover and now everything is ok. Thank you
Alessandro