Cisco NBAR Classification of ICMP from SAA Probe

[cdubois]

Hi All,
Looking for a little guidance.

From my PE I have an 2 MPLS-VPNs (RFC-2547) in which I am using MPLS-TE Tunnel for Transport. On the Customer Interface I have a Class Map Match Protocol ICMP IN and OUT.

From the CPE Routers I am using SAA to measure latency across the VPN. The ICMPs sent by the probe are classified by NBAR on the inbound, but not the outbound. My intial thought was enable a pre-classier on the Tunnel as the pkt is stacked with a label.

This does not seem to work. Any thoughts ???
Carl Dubois

 

[CiscoFreakazoid]

Why not try the Cisco 2600/3660/3700 Series Network Analysis Module!!

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_data_sheet09186a00801dcdfa.html

Cisco rulez!!

Have fun

Henk
CCNP/MCSE