Hi All,
Looking for a little guidance.
From my PE I have an 2 MPLS-VPNs (RFC-2547) in which I am using MPLS-TE Tunnel for Transport. On the Customer Interface I have a Class Map Match Protocol ICMP IN and OUT.
From the CPE Routers I am using SAA to measure latency across the VPN. The ICMPs sent by the probe are classified by NBAR on the inbound, but not the outbound. My intial thought was enable a pre-classier on the Tunnel as the pkt is stacked with a label.
This does not seem to work. Any thoughts ???
Carl Dubois
Looking for a little guidance.
From my PE I have an 2 MPLS-VPNs (RFC-2547) in which I am using MPLS-TE Tunnel for Transport. On the Customer Interface I have a Class Map Match Protocol ICMP IN and OUT.
From the CPE Routers I am using SAA to measure latency across the VPN. The ICMPs sent by the probe are classified by NBAR on the inbound, but not the outbound. My intial thought was enable a pre-classier on the Tunnel as the pkt is stacked with a label.
This does not seem to work. Any thoughts ???
Carl Dubois