I have a Cisco 7935 conference station with the obvious configuration for TFTP server such as 0.0.5.74. This station will boot up to the point where it is looking for TFTP server and wouldn't go any farther. Neither menu button nor any other buttons would respond. I wander if there is any way of resetting this station to a factory defaults. Someone suggested of setting a PC with tftp server to a requested TFTP ip address, but it is not possible to setup IP address to 0.0.5.74 on a PC. Please help!!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco 7935 Factory Reset
- Thread starter Shpuntic
- Start date
Here is the procedure to reset it to factory:
- Thread starter
- #3
Thank you for your answer, but as I mentioned before 7935 conference station would not go to a menu mode until it sees a tftp server, so it doesn't do any good if you press menu, star, or pound key at this screen. Here is what I have on my display:
Cannot contact TFTP server.
Contacting: 0.0.5.74
Cannot contact TFTP server.
Contacting: 0.0.5.74
- Status
Similar threads
- Locked
- Question
- Locked
- Question