Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 7914 with 7970 in Call Manager Express

Status
Not open for further replies.

Tbrennan3613

Technical User
Mar 23, 2008
8
US
Hello,

We just purchased a used 7914 for one of our 7970 IP phone, I have a 6-Pin phone cable and a extra power cube. I plugged the phone cord into the 7914 and the 7970, the used the extra power cube to power the 7914. All I get its red lights on all of the 7914's buttons.

The 7970 is powered by a Power Cube.
The 6-pin cable is straight thur and 25 feet.
We have a CME router with around 10 phones, 25 extensions.

Will the 7914 show up as a phone in the CME GUI?

Any help is appreciated.

Thanks!
 
I'm not familiar with CME, but on CUCM there is a drop-down on the 7970 configuration page for an expansion module. If it is not set for the 7914, you get the Christmas-tree result that you're seeing. I would poke around the 7970 configuration on CME to see if there is something for an expansion module.
 
Under your ephone:
ephone 1
type 7970 addon 1 7914

Then add your buttons below that. Make sure you have the 7914 load information under telelphony service like you do for your phones.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top