I have a 7841 that was working but stopped, phone just says searching for network. I reset the phone to factory settings and reprogrammed, phone worked fine for a day, today phone is not working, just says unprovisioned. I am not able to reset it to the factory settings now, any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco 7841 can not regester
- Thread starter Scparks
- Start date
gnrslash4life
MIS
Might just be a bad phone. Did you factory reset via the menus or the old traditional way?
Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
gnrslash4life
MIS
Whats funny is yesterday I actually had the same issue happen. Someone programmed two phones without any numbers.
Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
Search for the MAC on call manager and see if you find the phone and check if a line is configured for it.
Or do your phones require 802.1X authentication? Maybe this is turned off? I know you will get the "searching for network" messages if it is needed but not enabled.
Or do your phones require 802.1X authentication? Maybe this is turned off? I know you will get the "searching for network" messages if it is needed but not enabled.
- Status
Similar threads
- Locked
- Question
- Locked
- Question