Cisco 775 router ISDN timeout issue

[hason]

Hi,

I have an issue with our cisco 775 ISDN routers regarding timeout.

The routers are set to idle out after 2 minutes. The problem is that regardless of what traffic is going accross the line it always disconnects after 2 minutes.

I have adjusted the timeout threshold both up and down to no avail.

The connection is used for citrix with a minimal amount of screen change i.e. a minimal amout of traffic generated.

The router at the central site is a 1720, It's timeout has been changed yet the 775's idletime takes precedence.

I would be most grateful of any support you could offer.

Many thanks in advance

Jason Carr


SET USER RemoteNet
SET PROFILE ID 000000000000
SET PROFILE POWERUP ACTIVATE
SET PROFILE DISCONNECT KEEP
SET BRIDGING OFF
SET 1 NUMBER 01915652985
SET 2 NUMBER 01915652985
DEMAND 1 THRESHOLD 0
DEMAND 2 THRESHOLD 48
DEMAND 1 DURATION 1
DEMAND 2 DURATION 1
DEMAND D SOURCE LAN
DEMAND 1 SOURCE LAN
DEMAND 2 SOURCE BOTH
TIMEOUT 1 THRESHOLD 2
TIMEOUT 2 THRESHOLD 48
TIMEOUT D DURATION 120
TIMEOUT 1 DURATION 120
TIMEOUT 2 DURATION 120
TIMEOUT 1 SOURCE BOTH
TIMEOUT 2 SOURCE BOTH
SET PPP ADDRESS NEGOTIATION LOCAL ON
SET IP ROUTING ON
SET IP ADDRESS 10.1.1.2
SET IP NETMASK 255.255.255.0
SET IP FRAMING NONE
SET IP PROPAGATE ON
SET IP COST 1
SET IP RIP RECEIVE V1
SET IP RIP UPDATE OFF
SET IP RIP VERSION 1
SET IP PAT OFF
SET NETBIOS FILTER ON
SET IP ROUTE DEST 0.0.0.0/0 GATEWAY 10.1.1.1 PROPAGATE OFF COST 1
CD
SET BUTTON RemoteNet
SET SERIALPORT CONFIG
LOGOUT

 

[jeter]

cd remotenet
set timeout off Jeter@LasVegas.com
J.Fisher CCNA

 

[hason]

The ISDN line is not unmetered. Wouldn`t this command make the line permanent ?

 

[jeter]

no i would not think so. To set permanent you need to type this

set 1 pe on
set 2 pe on Jeter@LasVegas.com
J.Fisher CCNA