Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 6006

Status
Not open for further replies.

cmal00

IS-IT--Management
Jul 31, 2006
28
US
I have a Cisco 6006 that I can't telnet or ping to it. Yet the switch is up and running. I have three other switches running off it. I can ping the other switches. If I telnet into one of them and telnet from it into the 6006, i get "Password required, but none set". I can ping to it also.

Any ideas?
 
Telnet access has not been setup.

You have to console into it and make changes.
 
Ok, what about the no pinging?
 
I looked at the switch and telnet is enable.
 
Console in, and to set passwords on vty lines, assuming it is IOS and not CatOS...
switch>en
switch#conf t
switch(config)#line vty 5 15
switch(config-line)#password blabla
switch(config-line)#login
switch(config-line)#exit
switch(config)#enable password blabla
switch(config)#end
switch#wr
Is there an IP address set on the management VLAN, and is there a route to it?

Burt
 
It has CatOS. And yes there is a ip address with a route
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top