Cisco 4000M+ Flash

[12122053]

I got my hands on a 4000 M+ router which did not have a flash chip. I purchase a 8mb flash chip and inserted into the memory bank but I get a error when i boot up. Here is my console config: It seems to recognize the module. There is a IOS image loaded already on the flash. I can't reflash the router because i can't assign a ip address also I think the 4000 does not support xmodem transfer. I am able to get into Router(boot)# Could I load the IOS from here? Any steps i should do, thanks.

System Bootstrap, Version 4.14(7), SOFTWARE
Copyright (c) 1986-1994 by cisco Systems
4000 processor with 32768 Kbytes of main memory

Note: A random default MAC address of 0000.0c00.0d88 has been chosen.
Ensure that this address is unique, or specify MAC
addresses on commands (such as 'novell routing')
that allow the use of this address as a default.Flash: invalid chip id 0x101
unable to configure flash for erase or write.
Flash chips recognized by system :
Code Chip-Sz Cmd-grp Chip-name
89B4 0x20000 1 INTEL 28F010
89BD 0x40000 1 INTEL 28F020
01A7 0x20000 1 AMD 28F010
012A 0x40000 1 AMD 28F020
012A 0x40000 1 AMD 28F020
1CD0 0x40000 1 M5M 28F101P
89A2 0x100000 2 INTEL 28F008SA
01A4 0x80000 3 AMD 29F0

also sh version

4000 Bootstrap Software (XX-RXBOOT), Version 9.14(7), RELEASE SOFTWARE
Patchlevel = 9.1(11)
Copyright (c) 1986-1994 by cisco Systems, Inc.
Compiled Wed 18-May-94 05:07 by chansen

System Bootstrap, Version 4.14(7), SOFTWARE

Router uptime is 4 minutes
System restarted by power-on
Running default software


cisco 4000 (68030) processor (revision 0xB0) with 32768K/4096K bytes of memory.
Processor ID 5083644
DDN X.25 software, Version 2.0, NET2 and BFE compliant.
4 Serial network interfaces.
128K bytes of non-volatile configuration memory.
8192K bytes of Flash address space sized on CPU board.
Configuration register is 0x141

 

[wybnormal]

You can download the IOS by the RMON tftp commands. Follow the yellow brick road ;-)

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis4000/4000m/4000sig/4krommon.htm

MikeS
Find me at

http://www.packetattack.com

"Diplomacy; the art of saying 'nice doggie' till you can find a rock" Wynn Catlin

 

[mavenccie]

If the chip you bought has 4000 code on it, then all you should have to do is change the config-register 0x142(this one also ignores config), 0x2102(recommend), or 0x2142(this one also ignores config). If not, then:
You can load the router from the Router(boot)# Prompt. Use normal commands to turn on an interface and give it an IP address, and gateway if you need it. I could sit here and write the rest of the directions, but instead I will send you to a link.

http://www.cisco.com/warp/public/130/upgrade_index.shtml

 

[12122053]

Thanks for the info guys, personally i think is the wrong flash chip. When in I do a copy tftp flash i get a error stating" Flash address space not found". I'm getting a diffrent chip let's see how that works, thanks.