Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco 3845 for a PTP DS3 1
- Thread starter dcorrea
- Start date
-
1
- #2
- Thread starter
- #3
well it will vary depending on your carrier... but this is how mine looks, its in washington... it is frame-relay though ptp ide assume you could just lose the frame encap, lmi, traffic shaping, dlci and subinterface...
basically the telco does all the work in most cases and youjust configure your ip address and policies...
interface Serial1/0
description MPLS Connection
no ip address
encapsulation frame-relay
load-interval 30
dsu bandwidth 44210
framing c-bit
cablelength 10
serial restart-delay 0
frame-relay traffic-shaping
no frame-relay inverse-arp
frame-relay lmi-type q933a
!
interface Serial1/0.1 point-to-point
ip address x.x.x.x 255.255.255.252
frame-relay interface-dlci 100 IETF
basically the telco does all the work in most cases and youjust configure your ip address and policies...
interface Serial1/0
description MPLS Connection
no ip address
encapsulation frame-relay
load-interval 30
dsu bandwidth 44210
framing c-bit
cablelength 10
serial restart-delay 0
frame-relay traffic-shaping
no frame-relay inverse-arp
frame-relay lmi-type q933a
!
interface Serial1/0.1 point-to-point
ip address x.x.x.x 255.255.255.252
frame-relay interface-dlci 100 IETF
- Thread starter
- #5
- Status