Cisco 3750 connected to a NETGEAR ProSAFE GS748T

[mattbarkerlfc]

Hi,

I'm after a bit of help.

I'm trying to connect a Cisco 3750 to a NETGEAR ProSAFE GS748T. Both switch ports are in the default VLAN (1), and from the Cisco I can see the Netgear at layer 2 (it sees it as an LLDP neighbor), but it won't pass traffic.

Has anyone ever had an issue like this or knows about the Netgear to point out where I might be going wrong ? Today was the first time i've seen a Netgear switch and it isn't the best to navigate via the GUI.

Any help would be appreciated.

Thanks,

Matt.

 

[imbadatthis]

on the cisco side, what is the interface status? up/up?
actually just do a sh int status

We must go always forward, not backward
always up, not down and always twirling twirling towards infinity.