Have been going back and forth with ATT for about a week now. They thought the problem with 3 of our 4 t1's bouncing and taking errors was a smart jack in another office. Well after a few days the problem is still there. 3 of the T1's are still taking errors. One of the T1's however is rock solid, no errors. When I plug this 1 t1 that has no errors in any of the other csu's it follows that circuit, so unless I'm wrong, this should help prove it's not my equipment correct? Just today I replaced the WIC's and the same problem is still there. Granted, the errors aren't all that high at time, but sometimes when they do get higher, the 3 t1's taking errors will bounce up and down for a minute or two. Any advice what to do next? I can call att and they will dispatch someone out to check it, but they said if it ends up being something on my equipment, that it will be billed at a very pricey rate....