octavian10
MIS
Hello,
I have a couple of 3529 switches I decided to use in a temp office, they both have 2 gigabit ethernet GBIC slots and I cannot get any of them to work. When I plug in the 1000 BaseT GBIC's the switches recoognize them but I cannot get these two ports to come up. when I run the No Shutdown command the ports go up and then a second later they go back down. Is this an incompatibility issue as far as the GBIC's are concerned? I have 4 GBIC's and two switches they can't all be bad. Thanks in advance for you help.
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)
I have a couple of 3529 switches I decided to use in a temp office, they both have 2 gigabit ethernet GBIC slots and I cannot get any of them to work. When I plug in the 1000 BaseT GBIC's the switches recoognize them but I cannot get these two ports to come up. when I run the No Shutdown command the ports go up and then a second later they go back down. Is this an incompatibility issue as far as the GBIC's are concerned? I have 4 GBIC's and two switches they can't all be bad. Thanks in advance for you help.
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)