Cisco 350 AP

[LloydSev]

I had one of my APs start taking errors last night for no reason.. we really didn't do much looking, just know that it did not start working after a reload, but after refreshing it, it started working again..

anyone have any ideas?

my 2 other Cisco 350 APs were working just fine and had been running just as long.

 

[mingpayling2]

You appear to be having radio holdoff. This mean that you need to check your radio frequencies and ensure clear separation of channels.


A.K.Pollard

http://www.tribecaexpress.com

 

[LloydSev]

Well.. wouldn't it take less than 2 months for it to error if that were the case? ... just wondering..

and if so, how would I go about correcting this error?

I'm still learning, and I'd like to be a little prepared when I goto my superior and give him an idea of what it was...

 

[mingpayling2]

Radio Hold off occurs only when an interfering frequency enters your RF cell. Time is irrelevant. You can go to the Carrier Test and move to a channel with less interference. The carrier test can be found in Network Diagnostics.

 

[LloydSev]

Thank you, I'll try that.