Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 2911 configuration to a PBX

Status
Not open for further replies.

Aude974

IS-IT--Management
Nov 3, 2011
1
CI
Hi everyone

i have a router cisco 2911 which is use as a router and i have a voip system config. a cisco phone are connected to the router and the inside voice call is work properly. Nom i have plug a vic BRI card on the router and i would like to have outside call and i dont know very well how to do that ineed your help
 
Hello
First you will have to see if you have layer 2 connectivity,apply the below commands to the conf of the router and the do a "show isdn status" if you see "State = MULTIPLE_FRAME_ESTABLISHED" you are good to go and then I can help you with the dial-peer settings.

interface BRIx/x/x
isdn switch-type basic-net3 = Your ISP ISDN switch type
isdn overlap-receiving T302 5000 ??????
isdn not-end-to-end 64
isdn incoming-voice voice
isdn send-alerting
isdn sending-complete
isdn static-tei 0 ???????

voice-port x/x/x
compand-type a-law
cptone IT = Your Country Tones




Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top