Cisco 2801 to a 1841 using MPLS IPVPN can not access Inet on remote

[sparky40wv]

I have a location using an IPVPN with a Cisco 2801 at the primary office and a Cisco 1841 at the remote location...

The problem is that I can ping back and forth between locations, I can also access all servers and devices between each location... I can not however access the internet from the remote location, I can access the Inet from the main location however...

2801 FE0/1 interface to Internet FE0/0 Interface to local LAN Serial 0/0/0 Interface to MPLS Circuit

1841 FE0/0 Interface to local LAN Serial 0/0/0 Interface to MPLS Circuit...

I will post config scripts of each router shortly...

 

[burtsbees]

Without looking, is the remote LAN being NATted?

Burt

 

[sparky40wv]

yes, I have NAT on both remote and the primary sites...

 

[burtsbees]

Well, are you wanting all traffic from the remote site to go to the main site in order to get out to the internet? That's what it almost looks like you are trying to do...if so, you can only NAT at the main site. I am assuming that this is a site to site vpn, and not remote access (not familiar with the term "ipvpn").

Burt