cisco 2801 problem

[mackomisi]

Hi All,

I have a c2801 which doesn't work. All IOS I have tried do the same. After starting, send de following message then reset and jump into rommon.

May be a HW problem ? Any advise ?

thx,
mackomisi

--

Jul 25 12:29:37.727: %SMC-2-BAD_ID_HW: Failed Identification Test in 0/-1/-1 [7/0]

The module in 0/-1/-1 in this router may not be a genuine
Cisco product. Cisco warranties and support programs only
apply to genuine Cisco products. If Cisco determines that
your insertion of non-Cisco memory, WIC cards, AIM cards,
Network Modules, SPA cards, GBICs or other modules into a
Cisco product is the cause of a support issue, Cisco may
deny support under your warranty or under a Cisco support
program such as SmartNet.

 

[Minue]

Hello
What kind of WIC cards doyou have installed?Try taking all of them out to see if it boots properly.

Regards

 

[mackomisi]

Hi,

no WIC cards, no modules, router is empty. Removing CF too and boot from tftp server -> same problem.

regards,
imedve

 

[Minue]

Did the router ever work,what's the router story?Brought as used material,etc.Also as a last troubleshooting step try changing the DRAM.

Regards

 

[mackomisi]

Hi,

this is a used router I bought some weeks ago. It has 128 MB onboard RAM, cannot change. I really think it has a hw fault. Contact to the seller soon, fortunatelly it has 1 year warranty.

regards,
imedve