killersheep
Technical User
Hi all,
I have a cisco 2610 with IOS 12.3(10) with 1 T1 CSU/DSU and 64M Dram and 16M flash. I just bought a NM-4A/S module. Everything works fine on the router until I add the new module. Once I instal it and reboot I get the **PCI Exception Error** with some numbers below it. I will post the exact error message when I get home later. It does not seem to be passing the post test and errors almost immediately. Once I remove the module everything is fine again. Any help at all would be appreciated. I can also post any further info you may need about the router when I get home.
Thanks,
Killersheep
I have a cisco 2610 with IOS 12.3(10) with 1 T1 CSU/DSU and 64M Dram and 16M flash. I just bought a NM-4A/S module. Everything works fine on the router until I add the new module. Once I instal it and reboot I get the **PCI Exception Error** with some numbers below it. I will post the exact error message when I get home later. It does not seem to be passing the post test and errors almost immediately. Once I remove the module everything is fine again. Any help at all would be appreciated. I can also post any further info you may need about the router when I get home.
Thanks,
Killersheep