Cisco 2511 Probs

[cksrealm]

Hi All

I am in the process of currently doing my CCNA, for which I have been provided with a Cisco 2511 router to work with, when setting up the ethernet port and then issuing the no shutdown command it all appears to be working, however I am not able to ping the ip at all and then when running sh interface I am getting protocol up but line protocol down, you guys got any idea at all by the way.
Thanks
CK

http://www.ckssrealm.com

 

[cksrealm]

This is output from the sh interface command

thernet0 is up, line protocol is down
Hardware is Lance, address is 0010.7be8.3f9d (bia 0010.7be8.3f9d)
Description: connected to hub
Internet address is 192.168.0.4/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 205/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
65 packets output, 3900 bytes, 0 underruns
65 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
65 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

 

[cksrealm]

I have managed to fix this fault by the way by using the no keepalive command

 

[panca]

First, how you are accesing the router, through console ?
Second, some types of 2511 have AUI connector for LAN, you have to use AUI-UTP tranceiver and have proper cable connected to
a: for hub, or switch, normal UTP cable
b: for direct connection to PC lan card, must have crosover cable.
From the reading of sh int, it is obvious
65 lost carrier, 0 no carrier
there is no cable connected, hub faulty, tranceiver faulty, and the worse, port faulty.
Miroslav