Cisco 1841 Master/Slave help

[DougR1105]

Hi all kinda new to Cisco commands, my company is changing PTP T1 carriers and they are asking if my end is set to master or slave can anyone tell me the commands to find out the timing master/slave settings,, thanks in advance

 

[joeccie]

This should be related to clocking. By default, the router is set to line (slave) clocking.


Thanks,
Joe

http://Certificationchat.com

 

[DougR1105]

Thanks for the info but I need the actual command to check this to make sure both ends of my point to point are not set to slave..

 

[joeccie]

Post your configuration and a show version so I can see what T1 cards you have.

Thanks,
Joe

http://certificationchat.com