I'm trying to set up two 1720's point to point over a two wire local loop. The ATM connection comes up but refuses to pass layer three traffic, although when configured for bridging, it passes layer two. Any suggestions ?
ip subnet-zero
no ip routing
!
!
no ip domain lookup
!
!
!
!
!
interface ATM0
ip address 172.16.10.153 255.255.0.0
no ip route-cache
no atm ilmi-keepalive
pvc shdsl 0/1
!
dsl equipment-type CO
dsl operating-mode GSHDSL symmetric annex B
dsl linerate AUTO
bridge-group 1
bridge-group 1 spanning-disabled
!
interface FastEthernet0
ip address 172.16.10.152 255.255.0.0
no ip route-cache
speed auto
bridge-group 1
bridge-group 1 spanning-disabled
ip subnet-zero
no ip routing
!
!
no ip domain lookup
!
!
!
!
!
interface ATM0
ip address 172.16.10.153 255.255.0.0
no ip route-cache
no atm ilmi-keepalive
pvc shdsl 0/1
!
dsl equipment-type CO
dsl operating-mode GSHDSL symmetric annex B
dsl linerate AUTO
bridge-group 1
bridge-group 1 spanning-disabled
!
interface FastEthernet0
ip address 172.16.10.152 255.255.0.0
no ip route-cache
speed auto
bridge-group 1
bridge-group 1 spanning-disabled