CIL, call duration time

[bb34nne]

Some time ago, I sent a question regarding CIL. I have not received any response, :-(

I am interested in how the data is sent to the accounting program. Commands that I have set the following (CIL over Ethernet):

IOEQI:IODEV=CIL-ETH,EQU=1-1-22-4,TYPE=NETWORK,USAGE=OUT;
IONCI:IODEV=CIL-ETH,USER=CIL-1,RPORT=2000,IP=172.16.1.203;
CLDFI:IODEV=CIL-ETH,FILE=EZ,USER=CIL-1;
CLOHI:FILE=EZ,DMPSIZ=1,FORM=2;

To test I used Hyperterminal and data that arrive are not correct. Call duration time is not correct. Shows only four fields, while the documentation states that the call duration time needed five fields. Is there some clue by which one can get the exact time of the call to be calculated the exact cost.

I believe that someone has already dealt with this and know a solution for this problem.

Version of PBX is: CXP1010101/4/TSWSP02/R3A

If you need more data, I will send them here.

Thanks in advance!

 

[bb34nne]

Here are the rest of commands, sorry about this:

CLODI:FILE=EZ;
CLODI:FILE=EZ,ORIG=T001001001&&T001001015;
CLODI:FILE=EZ,ORIG=T001001017&&T001001031;

CLODI:FILE=EZ,ORIG=400&&499;
CLODI:FILE=EZ,ORIG=91;

bb34nne

 

[DUFQI]

PARNUM=122
States whether one second or six seconds resolution is selected in duration time field for CIL

1 One second resolution is selected
6 Six seconds resolution is selected

 

[bb34nne]

Thank you very much, that was the problem!

bb34nne

 

[bb34nne]

Now the seconds are OK, when I changed PARNUM 122.

Appeared a new problem, the two providers call duration time corresponds to real-time call (repeatedly tested).

At the third provider, call duration time shows wrong duration of the call. More precisely, on each call through the third provider, PBX adds a few more seconds(in my case, only international calls are wrongly shown). With these data can not be sure of the exact cost.

The third provider is connected to the analog exchange line (TL11). LCR is configured, and international calls pass through the third providers analog lines.

With other two providers, the PBX is connected with PRI trunks and call duration time is OK.

Why is the call duration time on the third provider shown wrongly? Maybe because analog trunks?
If someone knows a solution, please reply!

Thanks for your help!