Trying to cut over a conversion from Nortel MICS to Avaya IP Office with older DSS T1, Two way DID with E&M Trunks. If I program the new IP Office with E&M Switched 56k, I can make calls but can't receive calls, I have incoming set to auto answer. calling party hears no ringing. system status shows the call coming in but never rings the incoming call route destination phone. Could it be a problem with the answer timer?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Chennel setting for older DSS T1
- Thread starter peck4
- Start date
hairlessupportmonkey
IS-IT--Management
not that I know much about North American ISDN but
its a pretty old doc, but the principles might be the same?
ACSS - SME
General Geek
its a pretty old doc, but the principles might be the same?
ACSS - SME
General Geek
- Thread starter
- #3
- Status
Similar threads