Channelizing on Cisco T1

[RobG2001]

If I wanted set up two vlans on network, each to use a certain amount of bandwith of a private T1, how would it be done? Could I use the channel-group command and if so, what kind of WIC would be required? Any help would be appreciated.

RG

 

[alfa156]

I'm pretty sure you would need a network module. I think it would be a NW-1CT1.

 

[MelchiorKD]

not sure what your setup is, but you can always use custom queuing. 50% of bandwidth for vlan 1, 50% for vlan 2. can only do this if each vlan comes into the router on different interfaces

 

[jeter]

What type of router do you have? “Reserve your right to think, for even to think wrongly is better than not to think at all”

Fisher CCNA

 

[RobG2001]

It's going to be a 2621.