Channel Setup copy 2

[Altayan]

I have a loop with the below setup. I need to copy the setup on channels 1-8 to 9-16. What is the easiest way to do that or do I have to do it manually? Thanks.

DTI TRK LOOP 26 - ENBL
FFMT/LCMT/YALMT: ESF/B8Z/FDL
SERVICE RESTORE: YES
YEL ALM PROCESS: YES
ALARM STATUS : NO ALARM
CH 01 - IDLE TIE 3VCE CH 02 - IDLE TIE 3VCE
CH 03 - IDLE TIE 3VCE CH 04 - BUSY TIE 3VCE
CH 05 - BUSY TIE 3VCE CH 06 - BUSY TIE 3VCE
CH 07 - IDLE TIE 3VCE CH 08 - IDLE TIE 3VCE
CH 09 - UNEQ CH 10 - UNEQ
CH 11 - UNEQ CH 12 - UNEQ
CH 13 - UNEQ CH 14 - UNEQ
CH 15 - UNEQ CH 16 - UNEQ
CH 17 - UNEQ CH 18 - UNEQ
CH 19 - UNEQ CH 20 - UNEQ
CH 21 - UNEQ CH 22 - UNEQ
CH 23 - UNEQ CH 24 - UNEQ

 

[pronei]

It will be easiest to out all 8 and then rebuild them at 1 time.

LD 20
prt the tnb on one of the channels

then

LD 14
out 8

then
LD 14
new 16
and use the settings from one of the channels you printed earlier.

 

[steve64]

Print out one of the existing trunks, 26 8, and then in LD 14 enter New 8 and then enter the data from 26 8 except for the RTMB you will need to use the same Route but member number will be 1 number larger than on 26 8. When you press enter it will build all 8 of the trunks for you.

 

[Altayan]

thanks a lot guys