Changing TLAN on Signaling Server

[MrCSharp]

before i change i just want to make sure i have all the bases covered.

I am changing the IP Address From 192.168.20.60 to
192.168.0.20, moving it to a different subnet

So I need to change the TLAN address,VMG Address and Ip Node Address,Am I missing anything?

 

[tnphoneman]

Don't forget your DHCP scope if you are using it.

 

[Triton101]

modify all the phones to point to the new IP (unless you are using DHCP then the DHCP needs to be modified to point to the new address)

NRS (if its on this server) (and modify any entries that might be affected)

 

[MrCSharp]

where do i look at the NRS Triton?

 

[mattfx]

NRS, if it resides on your signaling server, should come up when you go to

http://192.168.20.60/nrs.

At least that's how mine works.

 

[Triton101]

If it's Succession 4.x and up you should have an entry for it in element manager if it was installed on the sig server. Should be in the same area as Dialing and Number Plans - Network Routing Service (only if you are using it)

 

[Triton101]

forgot to add,

drop any virtual trunk DCH (at the far end especialy) and re-enable them after the IP address change is made......if you are using virtual trunking or ITG Trunk, if you don't it might cause one way calls if you don't disable re-enable the Ds...