Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing TLAN on Signaling Server

Status
Not open for further replies.

MrCSharp

IS-IT--Management
Jun 7, 2005
59
CA
before i change i just want to make sure i have all the bases covered.

I am changing the IP Address From 192.168.20.60 to
192.168.0.20, moving it to a different subnet

So I need to change the TLAN address,VMG Address and Ip Node Address,Am I missing anything?
 
modify all the phones to point to the new IP (unless you are using DHCP then the DHCP needs to be modified to point to the new address)

NRS (if its on this server) (and modify any entries that might be affected)
 
If it's Succession 4.x and up you should have an entry for it in element manager if it was installed on the sig server. Should be in the same area as Dialing and Number Plans - Network Routing Service (only if you are using it)
 
forgot to add,

drop any virtual trunk DCH (at the far end especialy) and re-enable them after the IP address change is made......if you are using virtual trunking or ITG Trunk, if you don't it might cause one way calls if you don't disable re-enable the Ds...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top