Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing ALL default DNs BCM50

Status
Not open for further replies.

mrraymond

Technical User
Sep 25, 2010
27
TH
The entire "2" range is a part of the system wide CDP, thus I need to change all the default and application Dn's to leading digit "5".

I am using using four digit dialing. I individually changed each and every DN today taking more than 90 minutes of time, however I have got six more BCM's to do in the same fashion.

Is there any way to change all the leading DN default numbers in a faster way other than doing each one individually?

Thanks
 
Default the system and start from scratch.

Were u using the renumber button which would allow u to do a range of DNs?
 
Its really to late in the game to default the system ...i did not see any place to do a range of number changes.

I started with default DN 221......i then changed the system to 4 digits which resulted in 2221.... from there I went about changing each DN individually.
 
Under telephony->cold reset, you can specify the start DN. However you would be starting again with the telephony configuration.

Also you can specify the DN length as 4 digits (don't have a 50 to hand). Again, this would be a drastic change.

If you mean can you rename 221 & 222 & 223 to 500 & 501 & 502 (ie multiple change) - not on a 50, other than previous comments.

On a 450 you have smart configurator, so for example you can deconfigure and configure, and this does give you much more flexibility.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top