I have a couple of Cisco 2501 routers in my home lab. I was following the instructions on a Cisco netacad lab that asked that I change the baud rate of the routers console port to 115200. The instructions were for a newer router, I guess, but I did some research and found out that by changing the register value to 0x3922 I would get the desired settings. Now I can't access the router via Hyperterminal on Windows of minicom on Linux. I did make the changes on the terminals to 115200. I suspect the problem is that the 2500's don't support this baud rate? How can I fix this problem?