Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Change the Clock

Status
Not open for further replies.

PhoneStar

Technical User
Mar 27, 2014
52
US
I would like to move the secondary clock source to the commercial E1(loop 24), we are using two T1s (loop 9 & 26) at the moment; what do I need to do, is it possible to have one T1 and one E1?

CEQU
MPED 8D
TERM
REMO
TERD 010 011
REMD
TERQ
REMQ
SUPL 004 012 020 N064
N080 V096
SUPC
SUPF
XCT 000 016
TDS *000 *016
CONF *001 *017
MFSD *000 *016

DLOP NUM DCH FRM TMDI LCMT YALM TRSH
PRI 008 24 ESF NO B8S FDL 00
009 24 ESF NO B8S FDL 00
026 24 ESF NO B8S FDL 00
027 24 ESF NO B8S FDL 00
030 24 ESF NO B8S FDL 00
031 24 ESF NO B8S FDL 00
PRI2 024 025
DTI2
MISP 002 018 028
EXTO 3PE
CNI 012 000 000
EXT1 3PE
CNI 012 000 000
MCFN S0B0 S0B1 S1B0 S1B1 B2S0 B2S1 S3B0 S3B1 FLSH TOTL
016 016 016 016 000 000 000 000 64 128
 
Unless loop 24 is define and configure on the PBX - you can't do this. Your CEQU shows that loop 24 is not part of the PBX environment.
 
Can I make it part of the PBX environment, if so, how?
Should I make it part of the PBX environement? Is there a reason that I shouldn't?
Thanks
 
Loop 24 is part of the PBX environment. It's a 2.0 mb PRI, aka Euro PRI. We don't have those in the US and I have never set up clocking on one but it should be in the books.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top