Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Change SMGR with CS1000 integration

Status
Not open for further replies.

OzEzer

Technical User
Jun 29, 2014
13
IL
Hi everyone,
I need your help here.
I have just change the SMGR to new one ( different IP and hostname - different machine ).
The first integration of CS1000 with SGMR was made by other man so I don't know how to do it.
Here I need your help - could you try to help me configure it in my side ?

SMGR ver 6.3.11
CS1000 ver 7.6

Thanks a lot!
 
you will just need to reg the elements to the SMGR

Sig servers just web browse " address of FQDN>/local-login" complete the security config and restart services
Call Servers/MGC in LD 117 "reg ucm sys"

After that is complete and you see all you CS, MGC and SS in the element list of the CS1000 GUI you need to go into software deployment. On the software loads even though you are not going to deploy anything you will need to add the 7.6 nai file. Then on the deployment view right hand drop down select CS1000 Systems, click add CS1000, select your system TID from drop down, give it a name, click next and select you EM/SS for the system and commit. Change the view back to servers and see all your SS in a predeployed state, Commit them and you are done.
 
Thanks a lot!
I done all those, but, I can't see the MGC in the system manager.
And I got some error in the E1 ( trunk from Avaya CM to the Nortel ) : denial event 1193: Equipment congestion D1=0x830016 D2=0x45012a

Thanks!
 
You will need to register the MGC card also with the joinsecdomain command.
 
like KCFLHRC says login to your MGC's individually and run the joinSecDomain command (case sensitive), once done if you do a "stat ucm sys refresh" in LD 117 you will see them all registered also you will see them pop up in SMGR
 
Thanks!
can you tell me please how I can connect to the MGC ?
I have tried to connect to TTY0, but I don't know what to do next..
And when I try to telnet to the MGC and enter the admin password. he tell's me that the password has expired.
 
Ok on tty 0 you can do control ldb (local debug) or rlogin to the card username should be the callserver local admin2
 
He tell's me somthing about RADIUS or somthing like that... and not let me login.. that...
 
OK.
I manage to register the MGC in the SMGR, but I still got the same error on the E1.
How we can move on with that ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top